Since I've done a fair amount of fabrication with WPC Foam Board, I felt that this might be worthwhile to others who may have missed it on the bulletin board.

One modern material, that has received little or no attention for building a boat itself, is expanded wpc foam board. I use the stuff a lot for such items as tackle center casings and drawers, battery boxes, light weight doors and molding replacements that will either be painted or laminated. I usually use it in conjunction with polyethylene, (Seaboard, Starboard), exterior facings if the item isn't going to be painted. Also to be a replacement for plywood normally used for backing boards on such upholstered exterior items as bolsters, seats, benches, etc.

I just finished a 4 drawer tackle center for a small boat that is fully recessed into the console. The face molding, door and drawer faces are polyethylene, the rest WPC. I'll have that project up on the web within a week or so.

The cost for 4x8 sheets is comparable to marine ply, but when you back out the cost of epoxy encapsulation, it's less expensive by a third if you're not counting the cost of labor. Throw labor in and it's well under half the expense.

It's dissimilar to plywood in the respect of rigidity, (it's fairly limber by comparison), and it won't hold epoxy laminations as well as wood. But it is rot proof, UV resistant, easy to work with, non-toxic, stable, holds a fastener reasonably well, easily glued, (PVC cement), or hot air welded, water proof, highly paintable, and fairly easy to obtain through a variety of plastics dealers.

It takes well to a number of other adhesives, including, polyurethane, polysulfide, epoxy, contact cement, resorcinol, etc. Easy to fabricate using saw, drill, & power sanders. Faces are hermetically sealed and smooth, interior is somewhat course and on the spongy side. Cell structure is closed, will not absorb water. Can be heat and vacuum formed. Tortures easily, compound curves and shapes are no problem, but heat would be required.

If anybody wants to experiment with WPC Foam Board. and can't find a local source, call Mike at Sunray Plastics in Riviera Beach, FL - 561.844.7722. He'll ship, or drop ship, anywhere in North America. Be sure you tell him I gave you his phone number...

Thicknesses available range from 1/8" through several inches. Standard increments of 1/8". Virgin material is white. Reconstituted, which is denser, better machining, & lower cost is deck grey. Other WPC extrusions are common. Pipe, angle, & rod stock.

Actually this deflection ratio is rather ambiguous, since the closer the end length is to the fulcrum, the more pressure needed to effect the same deflection distance, and vise versa. But this little test shows graphically the difference of flexibility between the two materials.

This section of the boatbuilding tips was hastily done and will undoubetly be expanded as dicussion and thoughts progress. Check back from time to time. Email me with any comments and ideas that you might have...

If you have any questions, welcome to visit www.foamboardpvc.com/